Practical Advice

The worklight will flash three times and light up with reduced brightness just before it is about to switch off due to an empty battery.

You can use the utility hook (7) to hang up the worklight.

  • Do not use the utility hook to pull objects. The utility hook or the worklight could break.

You can use the tripod mount (5) to screw the worklight onto a tripod.

Attach the worklight firmly to the tripod. Ensure that the worklight cannot come loose and/or fall over.

Ensure that the tripod has a firm footing.

You can use the tripod quick-release mount (6) to mount the worklight onto a tripod.

Attach the worklight to the tripod.

Ensure that the tripod has a firm footing.

Note: A fall protection system that is suitable for the weight of the entire system should be used to prevent the worklight from falling. The maximum permitted length of the fall protection system is 0.5 m.

It is best to use the fall protection system with a tape loop secured by an anchor knot on the handle or a fall protection system with fall damper.

Please always refer to the operating instructions when attaching the fall protection system .

  • Select the fixed anchorage point  such that the worklight can fall freely into the fall protection system without putting the user at risk of harm in the event of a fall.It is essential the opposite side of the fall protection system is secured to a solid structure (e.g., building or scaffolding).
    The fall protection system must be able to move freely and may only be attached to the worklight in the permitted attachment area (8).