Actuation systems
Single actuation with discharge lock-off
With this actuation system, the discharge lock-off (1) must first be firmly pressed against the workpiece. A fastener is not discharged until the trigger (4) is pushed.
Afterwards, further discharging procedures can be actuated when the trigger (4) has been set back to the starting position and the discharge lock-off (1) is fully pushed in again.
Contact Actuation
With this actuation system, the trigger (4) must be pulled first and held in this position. Afterwards, the discharge lock-off (1) must be firmly placed against the workpiece in order to discharge the fastener. Further discharging procedures can be actuated by repositioning the tool elsewhere while pressing the trigger (4).