Starting Operation

Once you have inserted the rechargeable battery (7), the power tool will be ready for operation.

  • Firmly place the outlet (2) against the workpiece until the discharge lock-off (1) is fully pushed in.
    The worklight (3) switches on.
  • Afterwards, briefly press the trigger (4) and release it again.
    This discharges a staple.
  • For another driving procedure, completely lift the power tool from the workpiece and position it firmly at the next required location.
    Alternatively, you can press and hold the discharge lock-off (1) and press the trigger (4) to discharge another staple.

  • Press and hold the trigger (4).
    The worklight (3) switches on.
  • Firmly place the outlet (2) against the workpiece until the discharge lock-off (1) is fully pushed in.
    This discharges a staple.
  • For another discharging procedure, keep the trigger (4) pressed and completely lift the power tool from the workpiece. Replace it firmly in the next required position.
    This discharges another staple.

Note: Always wait until the staple has been fully discharged before lifting the power tool from the workpiece.