Speed Setting/Permanent Speed Setting
Setting the Speed
You can set the required speed using the two buttons (7), even during operation; see the following table. The required speed depends on the material and the working conditions; it can be ascertained through practical tests.
Permanent Speed Setting
You can use the two buttons (7) to set a default speed. Press and hold the ⊖ button for at least 5 seconds to call up the settings menu. Also press the ⊕ button for at least 5 seconds while pressing and holding the ⊖ button. The previously saved setting is indicated by the number of LEDs that flash white. You are now able to set a default speed as shown in the following table. To save the setting, simultaneously press and hold the ⊕ button and the ⊖ button for at least 5 seconds until the LEDs stop flashing.
LEDs | [min-1] |
|---|---|
Light 1 x white | 600 |
Light 2 x white | 1000 |
Light 3 x white | 1400 |
Light 4 x white | 1800 |
Light 5 x white | 2200 |
- The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories running faster than their rated speed can break and fly apart.
To deactivate a default speed that has been chosen, select the middle LED in the settings menu and save the setting as described.