Main Menu

Press the centre of the multi-function button (12) to get to the main menu.

Note: If a temperature probe is connected, none of the settings can be changed.

  • To scroll through a menu: Press the multi-function button (12) up or down.
  • To switch to a submenu: Press the right or centre of the multi-function button (12).
  • To change a menu option with the on/off switch: Press left or right on the multi-function button (12).
  • To change a displayed numerical value: Press left or right on the multi-function button (12). The value will change in faster steps if the button is pressed and held.
  • To save a setting and to return to the previous, higher-level menu: Briefly press the back button (11).
  • To return to the measuring screen: Press the back button (11) or the measure button (6).

In the upper part of the main menu, you can find the quick settings for both temperature alarms, the audio signal and the display brightness.

  • Press right or left on the multi-function button (12) to switch between the quick settings.
  • Press the multi-function button (12) in the centre to switch a temperature alarm or the audio signal on and off or to change the display brightness.

Note: The temperature alarms and the audio signal are switched on or off in the quick settings with the values and settings that are set in the menu options. To change the values/settings, you must open the relevant menu option.

In the lower part of the main menu, you can find the following menu options:

  • <Set alarms>
    • <Low alarm>: Set the temperature at which the minimum temperature alarm is triggered.
    • <High alarm>: Set the temperature at which the maximum temperature alarm is triggered.
  • <Measurement parameters>
    • <Emissivity>: A selection of saved emissivities is available for some of the most common materials. To make the search easier, the values are combined into material groups in the emissivity catalogue. First select the relevant material group and then choose the relevant material in the <Material catalogue> menu item. If you know the exact emissivity of the object you want to measure, you can also set it as a numerical value in the <User defined> menu item.
    • <Reflected temperature>: Set the reflected temperature.
  • <Tool settings>
    • <Laser>: You can switch the laser on or off via this menu item. The laser is used to indicate the measuring surface and should, therefore, only be deactivated in exceptional cases.
    • <Sound>: Under this menu item, you can change the sound settings. When you select <General>, an audio signal will sound when you switch the measuring tool on and off, during measurements or for errors. <Alarms> activates the audio signal when the temperature alarms are switched on. When you select <Button clicks>, an audio signal will sound every time a button is pressed.
    • <LED switch off after …‎‎‎>: Under this menu item, you can select the time interval after which the worklight will automatically switch off if no buttons are pressed. You can also deactivate automatic switch-off by selecting the <Never> setting.
    • <Tool switch off after …‎‎‎>: Under this menu item, you can select the time interval after which the measuring tool will automatically switch off if no buttons are pressed. You can also deactivate automatic switch-off by selecting the <Never> setting.
    • <Language>: Under this menu item, you can change the language used in the display.
    • <Factory reset>: Under this menu item, you can reset the measuring tool to factory settings. Select <Reset> to delete all settings or <Cancel> to cancel the process.
    • <SW>: Under this menu item, you can find the installed software version.