Starting Operation
- To switch on the power tool, press the on/off button (24) on the user interface (6).
The worklight switches on.
The on/off button indicator (23) lights up green when the tool is ready for use.
If single actuation is activated, the display (21) lights up white.
- To switch off the power tool, press the on/off button (24).
- Switch on the power tool.
The worklight switches on. - Firmly position the outlet (2) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (15) is pressed down completely.
- Afterwards, briefly press the trigger (4) and release it again.
This discharges a nail. - For another driving procedure, completely lift the power tool from the workpiece and position it firmly at the next required location.
- Switch on the power tool.
The worklight switches on. - Activate the contact actuation by briefly pressing the mode button (20).
The contact actuation display (22) lights up white. - Press and hold the trigger (4).
- Firmly position the outlet (2) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (15) is pressed down completely.
This discharges a nail. - For another discharging procedure, keep the trigger (4) pressed and completely lift the power tool from the workpiece. Replace it firmly in the next required position.
- Switch to single actuation by pressing the mode button (20) again.
The single actuation indicator (21) lights up white.