Status indications

The on/off indicator  also signals the status of the power tool as described below:

Status indicator for power tool

Colour

Meaning

Solution

Green

Power tool is switched on and ready to use.

–

Yellow

There is a problem that requires your attention: Critical temperature or battery is almost empty.

  • Leave the power tool to cool down.
  • Replace or charge the battery.

Red

The power tool is not ready for use.

Reason: Power tool has overheated, battery is empty or mechanical fault.

  • Leave the power tool to cool down.
  • Replace or charge the battery.
  • Have maintenance performed.

Flashing red

  • The second switch was pressed too early.
  • The second switch was not pressed within 5 seconds; the tool switches off automatically.
  • The switches were pressed in the wrong order (e.g. the trigger was pressed before the tool had switched to contact actuation mode)
  • Wait a short time until the status indicator display lights up green.
  • The power tool is ready for use again.
  • Perform the discharging procedure again, observing the correct order of pressing when doing so, or change the actuation mode via the user interface.