Dust/Chip Extraction

Do not perform work without taking dust-reducing measures. Using a suitable dust extraction attachment will reduce exposure to harmful dust. Provide good ventilation at the workplace. Always use suitable breathing protection. Use a dust extraction system that is suitable for the material wherever possible. The regulations on the materials being machined that apply in the country of use must be observed.

Requirements for the Dust Extractor

Recommended hose nominal diameter

mm

35

Required vacuum pressureA)

mbar
hPa

≥ 230
≥ 230

Required flow rateA)

l/s
m³/h

≥ 36
≥ 129.6

Recommended filter efficiency

Dust class MB)

A)

Power value at the power tool’s dust extractor connection

B)

According to IEC/EN 60335-2-69

Refer to the dust extractor’s instructions. If there is reduced suction power, stop working and eliminate the cause.

To ensure optimum extraction, the dust extraction adapter (29) must be cleaned regularly.

Insert the adapter for dust extraction (11) into the power tool from the front. It audibly engages. To remove, grasp the side of the adapter (11) and pull it off forwards.

Insert an extraction hose (dia. 35 mm) (31) (accessory) or a dust extraction adapter (29) (accessory). Connect the dust extraction hose (31) to a dust extractor (accessory).

The dust extractor must be suitable for the material being worked.

When extracting dry dust or dust that is especially detrimental to health or carcinogenic, use a special dust extractor.

For working on edges, you can use the dust extraction adapter for routing edges (30).

Attach the dust extraction adapter (30) with the knurled screw (4).

Remove the dust extraction adapter again when routing smooth plane surfaces.